2012 BMW FAG Parts


Showing 1 - 10 of 12 products
Image
SKU
Product
Rating
Price

FAG
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • Installation note: Bearing has a red seal side and a black seal side. Black seal should face inward towards center of the car.

Additional Fitment Information:
Vehicle Position
2012 - BMW 135i Rear

FAG
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • Hub assembly includes (4) 31 20 6 855 906 collar screws and (1) 31 20 6 795 249 collar bolt with compression spring.

Additional Fitment Information:
Vehicle Position
2012 - BMW 535i GT xDrive Front

FAG
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • Gen 3

Additional Fitment Information:
Vehicle Position
2012 - BMW 135i Front

FAG
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.

Additional Fitment Information:
Vehicle Position
2012 - BMW 128i Rear

FAG
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.

Additional Fitment Information:
Vehicle Position
2012 - BMW 335i xDrive Front

FAG
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • with 1.50 Thread Pitch
  • Important! Observe thread pitch : only in conjunction with (8) 31 20 6 872 920 spherical collar screw.
  • Gen 3

Additional Fitment Information:
Vehicle Position
2012 - BMW 535i GT Front

FAG
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • with 1.25 Thread Pitch
  • Important! Observe thread pitch : only in conjunction with (8) 31 20 6 872 920 spherical collar screw.
  • Gen 3

Additional Fitment Information:
Vehicle Position
2012 - BMW 740i Front

FAG
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • Must also replace (4) 31 12 6 760 203 hex bolt with washer
  • Per BMW, when replacing hub assembly, (4) 31 12 6 760 203 hex bolt with washer are required.
  • Gen 3
  • Front with Bearing

Additional Fitment Information:
Vehicle Position
2012 - BMW M3 Front

FAG
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • 45 x 84 x 41mm

Additional Fitment Information:
Vehicle Position Body
2012 - BMW 335i Rear Sedan

FAG
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • with 45 x 84 x 41mm

Additional Fitment Information:
Vehicle Position Body
2012 - BMW 328i Rear Sedan
Showing 1 - 10 of 12 products

Loading...